does alliance broadband supports bridge mode?

[leo08]

im using my own router as access point and not the alliance ont router and i recently setup adguard home dns but unfortunately it doenst work at all and idk why tried whatever i could but it just doenst work so wanted to know if alliance supports bridge mode so i can get full access and how to do it.

 

[Lucifer_King]

U can use any router or even a cheap ONU. Just make sure that u take a note of vlan and after changing ur router, tell them to reset mac. Better combo in ur case is buy any cheap onu. Set vlan (internet vlan) in ur ONU (lco will give u vlan info) then use a good router and in the router, set dns. Preferably use dns over https or tls whichever u prefer from adguard dns as alliance uses transparent dns rewrites so non encrypted dns records will be hijacked by alliance dns servers.

 

[leo08]

today i was going thru the ont router settings and in the wan configuration i saw theres two options in mode- route and bridge and currently its set to route. not sure if bridge mode works like this or not.

 

[Lucifer_King]

today i was going thru the ont router settings and in the wan configuration i saw theres two options in mode- route and bridge and currently its set to route. not sure if bridge mode works like this or not.

Yes that will work too. U just need to assign the lan ports to bridge mode and then connect own router's wan port to lan port