Good News Configured Airtel Fiber internet access on TP-Link XX530v XPON router

[Sparker0i]

You can setup VoIP on XX530v since your VoIP profile is IPv4 and can even run Zoiper to remotely call from your Airtel landline number using the PC/smartphone Zoiper app.

Create another XPON WAN profile on XX530v advanced settings. You can name it Airtel_VoIP or anything as per your choice.

Under Service type, select Internet & VoIP

Set VLAN ID to 660 and Priority to 4

Set Internet connection type to Static IP

Fill the VoIP IPv4 address, subnet mask and gateway. You can copy them from your Airtel router’s settings.

Since Primary DNS is mandatory to be filled on TP-Link, you can fill Google DNS (8.8.8.8) or Cloudflare DNS (1.1.1.1) there.

Under Advanced tab, keep NAT & IGMP Proxy checked.

Then click on Okay to create the Voice WAN profile.

Once that is done, go to Static Routing tab on the TP-Link XX530v. Fill the VoIP IP details by copying them from the Airtel router's Network setting -> Routing -> Routing table.

Once you have done these, we can proceed to telephone number addition.

Yes bro done

 

[Bapun]

Yes bro done

Bro, you need to check the Internet option also under Service type for this VoIP profile.

 

[Sparker0i]

Bro, you need to check the Internet option also under Service type for this VoIP profile.

Done

 

[IfranAli]

Yes bro done

enable Internet option as well.
and you have to create static routes as well, for ka.ims.airtel.in: 10.5.0.0/16, 255.255.0.0, 10.93.140.1 in gateway and Interface would be voip

 

[IfranAli]

@Bapun bro do you happen to know how to configure the VoIP here?

The ka.ims.airtel.in I picked up from my Airtel Router's admin page.

registrar address would be: 10.5.70.3, Password would be Nokia@1, SIP Proxy would be: ka.ims.airtel.in and Outbound proxy would be: 10.5.70.3

 

[Sparker0i]

registrar address would be: 10.5.70.3, Password would be Nokia@1, SIP Proxy would be: ka.ims.airtel.in and Outbound proxy would be: 10.5.70.3

No bro didn't work. Is this correct?

 

[IfranAli]

No bro didn't work. Is this correct?

disable outbound proxy checkbox

 

[Sparker0i]

disable outbound proxy checkbox

Still didn't work. Were the other details correct?

 

[Bapun]

Still didn't work. Were the other details correct?

Yes, they are looking correct.

You can go to NAT Forwarding and disable the last three ALGs.

 

[Sparker0i]

Yes, they are looking correct.

You can go to NAT Forwarding and disable the last three ALGs.

Still shows status X symbol